THREAD NAVIGATION:  
    Where am I?   Original message   Top of thread   Current page 
Displays all thread messages Displays thread map That to which this responds This thread's lead message Your most recent Tavern page

Hey again
04/11/2008, 22:54:11

    JBudOne writes:

    Hey guys. I did a check on the two executable to confirm that, yes, they were both written in C++. I also grabbed LithTech2 tools and attempted to load up Legends and MM9 using DEdit. Both of which loaded but neither worked (as far as I know). I went to the classes section and found a red dot beside each of the classes, and could not view any. I'm wondering if this is an issue related to the fact that I couldn't install NOLFTools (since NOLF was not installed on my computer).




Reply to this message   Back to the Tavern  

Replies to this message